SPEECH AND SOUND CONTROL
14 D-306232 WP8010/WP8030 V18 DSC EN USER
3. Speech and Sound Control
Speech & Sound Cont. Push-buttons
The sound and speech-related functions offered by the control panel are controlled with the keypad, as detailed
in the following list.
When partitioning is enabled:
Sound and speech-related features only apply to the partition(s) where the control panel is present. An activity
performed via the control panel from another partition will be displayed and the LED will light. The operation will
be added to the log file but will not be heard over the control panel speaker.
Increases the loudness of spoken messages
Decreases the loudness of spoken messages
Enables / disables the loudspeaker
Records a spoken message for other users of the alarm system
Allows listening to a recorded message left by another user of the alarm system
Enables / disables the chime function in chime zones
Voice ON/OFF
You can switch spoken announcements on and off by alternate clicking of the <7> key, as shown below.
Note: The system will maintain the “Voice OFF” state until subsequent selection of “Voice ON‟.
Message Exchange
For message exchange you can record a verbal message for other users of the alarm system. Face the panel,
press <2> and keep it pressed. When the display reads TALK NOW, start talking. The 5 dark boxes will slowly
disappear one by one, from right to left, as shown in the diagram below.
Refers to WP8030 with voice option only
To Next Page
Loading...
Need help?
General
