DSC WP8030 User Manual

MENUS AND FUNCTIONS
D-306232 WP8010/WP8030 V18 DSC EN USER 27
B.5 Programming the Duress Code
*
A. To Program the Duress Code
Additional Information (section B.5)
1
For detailed instructions on how to select the setting options – refer to sections A.1 and A.2.
2
The display shows the default duress code (2580).
3
Do not set the duress code the same as an installer or user code.
4
To end this session and to select other menu options or to quit programming – follow the instructions in
section A.2.
B.6 Add / Delete Proximity Tags
A proximity tag may be assigned to each of the WP Panel user codes 1-8 / WP Panel user codes 1-32 that can
be used instead of the user codes to perform a variety of functions, for example, arming, disarming, reading the
event log, etc.
Whenever a user code is required you can simply present a valid proximity tag instead of entering the user
code. Each tag should be assigned with a serial No. 1-8 (WP Panel) / 1-32 (WP Panel ) that corresponds to the
User Code No. 1-8 (WP Panel ) / 1-32 (WP Panel ) and enrolled into the system correspondingly.
The partition
*
authorization of the tags is identical to their corresponding user codes. For example, proximity tag
3 is assigned to user code 3.
 Here you can add (enroll) new proximity tags or delete tags as required.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Add (Enroll) a Proximity Tag
1.
PROXIMITY TAGS
Enter the [USER SETTINGS] menu, select the [PROXIMITY TAGS] option
and press .
1
2.
ADD NEW TAG
The display will read [ADD NEW TAG].
3
To begin the process of enrolling a new proximity tag press .
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
Present the proximity tag to the control panel within the timeout period.
4.
DEVICE ENROLLED
If enrollment was successfully completed, a "Happy Tune" ☺ sounds and
*
Duress Code is not applicable for UL installations
A duress (ambush) alarm message can be sent to the Monitoring Station if you are forced to disarm the system under
violence or menace. To initiate a duress message, you must disarm the system using a duress code (2580 by default).
1.
DURESS CODE
Enter the [USER SETTINGS] menu, select the [DURESS CODE] option and
press .
1
2.
DURESS CODE 2580
At the blinking cursor position, key in the Duress Code you wish to program,
for example, 6973.
2, 3
3.
DURESS CODE 6973
When the duress code you wish to program appears on the display, press
.
☺ Return to step 1
A "Happy Tune" ☺ sounds. The display confirms the saved code.
4

DSC WP8030 Specifications

General

Brand	DSC
Model	WP8030
Category	Control Panel
Language	English