72 D-306232 WP8010/WP8030 V18 DSC EN USER
SIA CP01 standards:
For SIA CP01, a siren must be used in the system installation.
This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS standard(s). Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received
or that may cause undesired operation.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisee aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
FCC STATEMENT
The 915 MHz model of this sensor complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This sensor may not cause harmful interference, and (2) this sensor must accept any interference that may be received,
including interference that may cause undesired operation.
The digital circuit of this sensor has been tested and found to comply with the limits for a Class B digital sensor, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio and television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this sensor does cause such interference, which can be verified by turning
the sensor off and on, the user is encouraged to eliminate the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the sensor and the receiver.
– Connect the sensor to an outlet on a circuit different from the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the device should be located at a distance of
at least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated
in conjunction with any other antenna or transmitter.
At 915 MHz the product complies with FCC requirements.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO or TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER‟S
AUTHORITY TO OPERATE THE EQUIPMENT.
WARNING! Owner's instruction notice: "Not to be removed by anyone except occupant".
If the “WP Panel” causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. If advance notice is not practical, you will be notified as soon as possible. Also, you
will be advised of your right to file a complaint with the FCC if it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation
of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
If trouble is experienced with the “WP Panel” for repair or warranty information please contact
Digital Security Controls , 3301 Langstaff Road , Concord, Ontario, Canada , L4K 4L2, phone number: (905) 760 - 3000, URL:
www.vdsc.com. If the equipment is causing harm to the telephone network, the telephone company may request to disconnect the
equipment until the problem is resolved.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are
discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not
to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
©2016 Tyco International Ltd. and its Respective Companies. All Rights Reserved.
Toronto, Canada www.dsc.com
Printed in Israel
WP8010/WP8030 V18 DSC EN USER D-306232 Rev 1(4/16)
To Previous Page
Loading...
Need help?
General
