DSC WP8030 User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
50 D-306232 WP8010/WP8030 V18 DSC EN USER
Event notifications by SMS
Note: This feature is not to be not to be enabled in UL Listed product.
The WP Panel system when equipped with a GSM unit can be programmed to send SMS event notification
messages to 4 pre-selected telephone numbers - see Chapter – 6, B.11. The messages can be tagged with a
"House ID" name, for example, "JOHN'S HOUSE", see Remote Control by SMS section, command no. 10.
Example of the reported SMS messages:
 JOHN‟S HOUSE
**AWAY**
 JOHN‟S HOUSE
**DISARM**
 JOHN‟S HOUSE
WP Panel: LOW BATTERY
GARAGE: LOW BATTERY
 JOHN‟S HOUSE
STATUS MESSAGE 01
(Event list is displayed)
Note: Status messages can be sent only to a calling telephone whose identity number is not blocked by the user!
Remote Control by Telephone
Note: This feature is not to be not to be enabled in UL Listed product.
The WP Panel allows you to initiate calls from your private telephone to the WP Panel control panel via PSTN
(landline) or GSM and to perform a variety of arming commands remotely using your telephone's keypad.
To connect to the WP Panel when the WP Panel is connected to the PSTN:
1. Dial the WP Panel PSTN tel. No.
2. Wait for 2-4 rings then hang up.
1
3. Wait 12-30 sec.
4. Redial WP Panel tel. No. (sound will be heard for 10 sec.).
5. [*] (to stop the sound)
6. [User code], [#]
2
7. [Desired command]
To connect to the WP Panel when the WP Panel is connected to the GSM:
1. Dial the WP Panel GSM tel. No. (sound will be heard for 10 sec.)
2. [*] (to stop the sound)
3. [User code], [#]
2
4. [Desired command]
Notes:
(1) Entering of user code is required once only.
(2) If you wait more than 50 seconds (may change according to setup / use) without keying a command, the WP
Panel will disconnect the line.
A. Executable Commands
Command
Single Partition Keying
Sequence
All Partitions Keying Sequence
1
Disarming
[]

[1]

[#]
[]

[0]

[partition]

[1]

[#]
2
Arming Home
[]

[2]

[#]
[]

[0]

[partition]

[2]

[#]
3
Arming Home-Instant
[]

[2]
[
1]

[#]
[]

[0]

[partition]

[2]
[
1]

[#]
4
Arming Away
[]

[3]

[#]
[]

[0]

[partition]

[3]

[#]
5
Arming Away-Instant
[]

[3]

[1]

[#]
[]

[0]

[partition]

[3]

[1]

[#]
6
Arming Away-Latchkey
[]

[4]

[#]
[]

[0]

[partition]

[4]

[#]
7
Arming Away-Instant-Latchkey
[]

[4]
[
1]

[#]
[]

[0]

[partition]

[4]
[
1]

[#]

DSC WP8030 Specifications

General

Brand	DSC
Model	WP8030
Category	Control Panel
Language	English