MENUS AND FUNCTIONS
D-306232 WP8010/WP8030 V18 DSC EN USER 23
1. Zones will be bypassed throughout one disarm-arm period only. Disarming the system after arming will
suspend the entire bypassing scheme but you can recall and reuse it as described in section B.3.
2. Fire zones cannot be bypassed.
3. Carefully read the section titled "Additional Information" according to the indicated references
1
etc –
see table at end of section B.3.
REMEMBER – ZONE BYPASSING COMPROMISES SECURITY!
A. To Bypass a Zone
Enter the [USER SETTINGS] menu
1
, select the [SET ZONE BYPASS]
2
option and press .
The first zone, Z01, is displayed.
3
Click the or button until the display reads the zone you wish
to bypass (or clear bypass), for example, "Z04" for Zone 04. After several
seconds the LED on the respective device starts flashing indicating "it's me".
When the display reads the zone you wish to bypass press .
The display now reads [<OK> TO BYPASS].
5
To bypass the selected zone press
A "Happy Tune"
☺ sounds and the updated zone status is now displayed
i.e. [
Z04: BYPASSED
].
8
B. To Clear a Bypassed Zone
Repeat steps 1 to 2 above.
When the zone you wish to clear bypass appears on the display (for
example, "Z04"), press to confirm. You can also identify the device
by looking for the "it's me" LED indication on the displayed device.
The display now reads [<OFF> TO CLEAR].
5
To clear the bypassed zone, press the button.
A "Happy Tune"
☺ sounds and the updated zone status is now displayed,
i.e. [
Z04: READY
] or [
Z04: NOT READY
].
9
To Next Page
Loading...
Need help?
General
