MENUS AND FUNCTIONS
30 D-306232 WP8010/WP8030 V18 DSC EN USER
If a valid ID was entered, a "Happy Tune" ☺ sounds and the display reads
[ID ACCEPTED] for a short duration and then changes to read the keyfob's
details. Continue to step 5.
The display shows the allocated keyfob serial No (user No.), which is always
the first free number, and the keyfob's ID number; for example:
[F01:Keyfob] alternating with [ID No. 300-5786].
To assign the keyfob to another user, for example, "User No. 5", key in [05] or
alternatively click the or button until the display reads
[F05:Keyfob] and then press to confirm.
The display reads [
DEVICE ENROLLED
] or [
ID accepted
] if the keyfob was
enrolled manually by entering the ID number, a "Happy Tune" ☺ sounds
and the display will then change to [
F01:Keyfob
].
5 6
B. To Set Partitions Authorization
The display will read [F05:PARTITIONS]. To enter the menu, press .
10
Use the keypad keys , , to change the status of the
partitions P1, P2 & P3, respectively.
11
When you are satisfied with the setting, for example, User 5 is authorized with
Partition 1 and 3 only, press to confirm.
A "Happy Tune" ☺ sounds. The display confirms the Partition setting.
12
C. To Delete a Keyfob
Enter the [USER SETTINGS] menu, select the [KEYFOBS] option and press
.
1
The display will read [ADD NEW KEYFOB].
Click the button until the display reads [DELETE KEYFOB].
The display will read [F01:Keyfob] alternating with the ID number of the keyfob.
3
Key in the keyfob number you wish to delete, for example, [06] or
alternatively click the or button until the display reads the
keyfob number, for example, "F06:Keyfob" and "ID No. 300-5799".
When the keyfob you wish to delete appears on the display, press .
7
The display now reads [<OFF> TO DELETE].
8
To delete the keyfob press the button.
13
When PARTITIONING is enabled.
To Next Page
Loading...
