E
51
2) Move the cold start lever (1) to (B,fig. 45).
3) Check that the stop switch (2, fig. 46) is positioned to
(RUN), then press the starter button (3, fig. 46). This model
features servo-assisted starting. Press and immediately
release the start button (3) to use the servo-assisted engine
starting function. When you press the button (3) the starter
motor operates automatically for a MAX time determined
by engine temperature. The system disengages the starter
motor as soon as the engine starts. If the engine fails to
start, wait at least 2 seconds before pressing the start
button (3) again.
Allow the engine to start on its own, without turning the
throttle twistgrip.
Notes
If the battery is flat the system automatically
disables operation of the starter motor.
4) Slowly move the cold start lever (1) to its vertical
position (A, fig. 45).
Important
Do not rev up the engine when it is cold. Allow some
time for the oil to warm up and reach all points that need
lubricating.
A
1
B
fig. 45
3
2
fig. 46
ProCarManuals.com
To Next Page
Loading...
