Audio
This section of settings allows setting of connection type of relevant audio
equipment
Digital audio output mode: you may switch the mode of digital output
PCM (Pulse Code Modulation, forced conversion): a mode in which original
track, i.e. Dolby Digital or DTS, is converted in Pulse Code form. It is supported
by decoders of virtually any up-to-date audio equipment. But this mode is only
recommended in case that your AV receiver does not support full decoding of multi-
channel sound of formats above, or a TV set (no home theater system) is connected
through a digital cable to your player
if specific sound track and specific playback mode are supported
Original (Bitstream): a mode, in which original sound tracks, i.e. Dolby Digital or
DTS, are transmitted to an external decoder in original form. Ref. Transmission of
digital audio signal to AV receiver
if specific sound track and specific playback mode are supported
System setup
22
Chapter 5
To Next Page
Loading...
