Duplo DC-6 - Table of Contents

xii
Chapter 2
Chapter 1
Contents
Introduction
............................................................................
i
Notes on Safety (Please Read and Observe)
....................................
iv
Safety Precautions
.............................................................
iv
Locations of Warning Labels
.................................................
viii
Interlock System for Safety
....................................................
x
● What is the interlock system for safety?
..................................
x
Machine Dimensions and Required Space for Operation
...............
xi
Before Using This Machine
Part Names and Their Functions
....................................................
2
Appearance
.......................................................................
2
Appearance (Feed Side)
.......................................................
3
Appearance (Ejection Side)
....................................................
4
Inside
...............................................................................
5
Control Panel
.....................................................................
6
LCD Panel
........................................................................
7
Turning Power ON/OFF
...............................................................
8
Turning Power ON
...............................................................
8
Turning Power OFF
.............................................................
9
Preparation Before Use
.............................................................
10
Loading Documents
...........................................................
10
Setting the Exit Tray
...........................................................
11
Installing the Perforation Unit
...............................................
11
Removing the Perforation Unit
..............................................
13
Changing the Perforation Tool Position
....................................
14
Changing the Perforation Tool Depth
......................................
15
Attaching the Card Stacker
..................................................
16
Adjusting the Card Stacker Guides
.........................................
17
How to Connect the DC-616 to Your Computer
..................................
19
Before Preparing Document
........................................................
20
Defi nition of Programming Terms
...........................................
21
Limit of Slit
......................................................................
27
Limit of Trail Cutting
...........................................................
28
Programming JOB on Control Panel
Before Programming JOB
...........................................................
32
Programming a JOB on the Control Panel
........................................
33
Programming a New JOB (Advanced Mode)
.....................................
35
Programming a New JOB (Simple Mode)
.........................................
41
Changing the Stored JOB
...........................................................
43