Duplo DC-6 - Programming a New JOB (Advanced Mode)

Programming JOB on Control Panel
35
2
Programming a New JOB ( Advanced Mode)
Turn on the power.
(
Make sure the standby screen is displayed on the LCD panel.
Press the F key.
The Select menu screen will appear.
Select Enter JOB using the CURSOR (Up/Down) key and press
the SET key.
Hints for entering a JOB:
● Pressing the SET key goes on to the next step.
● Pressing the CURSOR (Up) key returns to the previous step.
● Pressing the CURSOR (Down) key goes on to the next step.
● Pressing the STOP key during JOB entering returns to the standby screen.
● Pressing the RETURN key returns to the previous screen.
Select a JOB number (01–80) using the NUMERIC keys or the
CURSOR (Up/Down) key, and then press the SET key.
Select menu
Retrieve JOB
Enter JOB
Setting
JOB** entry
01: **************
02: **************
03: **************