Duplo DC-6 - Skew Compensation

57
2
Adjusting Feeder
Basic Operations
3
If the fi nished products are cut obliquely, adjust the
skew using the skew adjustment knob.
Skew Compensation
Press the TEST key to perform a test run for one
sheet and check the fi nished products.
Clockwise : Turning the knob slightly shifts the
lead edge of the document toward the
operator's side.
Counterclockwise : Turning the knob slightly shifts the
lead edge of the document toward
the non-operators side.
If the skew remains, repeat the above steps 1 and 2 again.