Duplo DC-6 - Document Preparation Basics

20
Before Preparing Document
The DC-616 can save up to 80 patterns of JOB. JOB contents can be programmed either via
computer or on the control panel. This chapter describes items required to program a JOB.
Slit : The DC-616 has six slitters. Two slitters (1, 2) are for the margins and the remaining four
slitters are for the center area of the document.
Cut : There is a guillotine cutter that performs cuts perpendicular to the document feed
direction. The DC-616 can cut up to 25 cuts on one document.
Crease : There is a creaser that performs creases perpendicular to the document feed direction.
The DC-616 can crease up to 20 creases on one document.
135
246
1
3
5
6
4
2
8
9
7
8
9
10
1
3
5
6
4
2
No. Name Function
1 Slitter 1
Cuts off the margin of the non-operator’s side.
Drops the margin slit by the slitter into the waste box.
2 Slitter 2
Cuts off the margin of the operator’s side.
Drops the margin slit by the slitter into the waste box.
3 Slitter 3 Cuts parallel to the document feed direction.
4 Slitter 4 Cuts parallel to the document feed direction.
5 Slitter 5 Cuts parallel to the document feed direction.
6 Slitter 6 Cuts parallel to the document feed direction.
7 Gutter defl ector
The gutter strips cut off by slitters are dropped into the waste
box.
8 Cutter section Cuts perpendicularly to the document feed direction.
9 Creaser section Creases perpendicularly to the document feed direction.
10
Perforation unit (Optional on
115V model and 230V Asia
model)
Perforates parallel to the document feed direction.
Crease
Cut
Slit 1
Slit 2
Slit 3
Slit 4
Slit 5
Slit 6
Document and processing position