Duplo DC-6 - Changing Perforation Tool Position

14
Preparation Before Use
REFERENCE
Do not touch the perforation tools.
This could result in injury.
WARNING
IMPORTANT
Inside of the perforation unit.
Loosen the two hexagon socket set screws each of
the two perforation tool assys (each side). (upper
tool: 1 pce., lower tool: 1 pce.)
Loosen the two hexagon socket set screws each of
the three roll assys. (upper roll: 1 pce., lower roll: 1
pce.)
When the hexagonal socket set screw does not
face toward you, rotate the shaft as shown in the
right fi gure to change the direction.
Move each perforation tool assy to the position
where you want to perforate with your fi ngers.
Changing the Perforation Tool Position
Roll assy
Upper roll
Upper tool
Perforation tool assy
Lower roll
Lower tool
Loosen the hexagon socket set screws which
suit the supplied hexagon wrench size.
REFERENCE
Move the roll assy to the center and the both sides of the document.
Position adjustment of the roll assys may need depending on the document thickness and
JOB type.
Roll assy
Roll assy
Roll assy
Perforation tool assy
Perforation tool assy