12
Preparation Before Use
Move the perforation tool assys.
(See → P.14 Changing the Perforation Tool Position)
Adjust the depth of the perforation tool.
(See → P.15 Changing the Perforation Tool Depth)
Tighten the two thumbscrews loosened in step 2.
Install the perforation unit on the ejection side of
the DC-616 by tightening the two perforation unit
installing screws..
Select a JOB containing perforation process and perform a test run for one sheet.
Check the processed positions on the fi nished product.
When you change the perforation positions, repeat steps 2 to 7.
To Next Page
Loading...
