Programming a New JOB (Simple Mode)
42
REFERENCE
Slit position setting order:
• Advanced mode : Slits are set in numerical order
from Slit 1 to Slit 2.
• Simple mode : Slits are set in alphabetical order
from Slit A to Slit F.
In Simple Mode, when the document width is bigger than 327.3
mm (12.8 inches) and a margin slit on the operator’s side is
smaller than 3.2 mm (1/8 inch), the warning message on the right
appears and then the slit entering screen appears. This is an
impossible JOB to process. Re-enter correct margin.
Document feed
direction
Document feed
direction
Document feed
direction
● Examples of impossible JOBs to process
• No left margin and no slit
• Right margin only
• Right margin and center slit only
REFERENCE
Exceeding max
fi nished size
Set margin slit
positions.
SlitB
***.*mm
(0/***.*-***.*)
JOB** entry
123456
Document feed direction
ABCDEF
Enter the value for SlitB to SlitF in a similar way to step 16.
When each input is complete, press the SET key.
When you require fewer than six slits, enter 0 after the last slit
setting and then press the SET key.
Hereafter, follow steps 18 through 31 in the Programming a New JOB (Advanced mode) for
each setting.
(→P.38)
To Next Page
Loading...
Need help?
General
