55
2
Automatic Setup Using Barcodes
Basic Operations
3
By pressing the START key, the built-in CCD reads the barcoded JOB number, then starts
processing the suitable JOB.
IMPORTANT
Make sure that BC appears on the standby screen after
setting.
The fi nished products are ejected.
IMPORTANT
Slit waste accumulates in the waste box.
Open the front cover and remove them periodically.
Accumulation of waste may cause paper jam.
Read Barcode
Settings
ON OFF
*/**
Attach the back guide and the side guides.
Set Read Barcode to ON in Settings.
To Next Page
Loading...
Need help?
General
