Duplo DC-618 - Page 108

88
When Messages Appear
Message Status and Solution
J06- * CHECK CUTTER/CREASER/
SLOT1/2/3
Remove documents from Cutter/
Creaser/Slot1/2/3 section.
to clear
Status: A document jam has occurred in the cutter/
creaser/slot1/2/3 section.
Solution: Remove the jammed documents from the cutter/
creaser/slot1/2/3 and then press the STOP key.
(→ p.98 J06- * CHECK CUTTER/CREASER/
SLOT1/2/3)
J07- * CHECK EXIT TRAY
Remove documents from exit tray.
to clear
Status: A document jam has occurred in the exit section.
Solution: Remove the jammed documents from the exit
section and then press the STOP key.
(→ p.102 J07 CHECK EXIT TRAY)
J08- * WASTE BOX FULL
Remove wastes from waste box
to clear
Status: The waste box has become full during processing
of documents.
Solution: Remove the accumulated waste from the waste
box and then press the STOP key.
(→ p.103 J08 WASTE BOX FULL)
J09- * CHECK THE CUT WASTE
CHUTE SECTION
Open the front door and remove the
documents from cut waste chute
section.
to clear
Status: A document jam has occurred in the cut waste
chute section.
Solution: Remove the jammed documents from the cut
waste chute section and then press the STOP
key.
p.105 J09 CHECK THE CUT WASTE CHUTE
SECTION)
MARGIN-* LOCK
Check documents in margin section
to clear
Status: The right (or left) tool of the margin slitter is
locked.
* shows R (right) or L (left).
Solution: Remove the documents from the margin slitter
section and then press the STOP key.
(→ p.98 J06- * CHECK CUTTER/CREASER/
SLOT1/2/3)
SLOT#-* LOCK
Check documents in Slot section
to clear
Status: The right (or left) tool of the module in the slot (2
or 3) is locked.
# shows a slot number.
* shows R (right) or L (left).
Solution: Remove the documents from the slot (2 or 3)
section and then press the STOP key.
(→ p.98 J06- * CHECK CUTTER/CREASER/
SLOT1/2/3)
GUTTER# LOCK
Check documents in gutter section.
to clear
Status: The gutter defl ector (1 or 2) is locked.
# shows a gutter defl ector number.
Solution: Remove the documents from the gutter defl ector
section and then press the STOP key.
(→P.88 p.98 J06- * CHECK CUTTER/
CREASER/SLOT1/2/3
CUTTER LOCK
Check documents in cutter section.
to clear
Status: The cutter is locked.
Solution: Remove the documents from the cutter section
and then press the STOP key.
(→ p.98 J06- * CHECK CUTTER/CREASER/
SLOT1/2/3)