74
12. STITCHER HEAD
Adjusting handle
Feed wheel
Wire tube lower
77
77
7
Mount the adjusting handle onto the feed
wheel, rotate to the right, so that the
wheels grip the wire.
88
88
8
Feed the wire with the handle.
Rotate the handle clockwise about two times.
NoteNote
If the wire is bent, it will not enter the wire
tube, and jam instead. Pull the wire, cut off
the bent part, and feed it again.
66
66
6
Insert the wire into the tip of the wire tube
upper, and feed with pliers.
Be careful not to bend the wire.
Feed until the wire reaches the feed wheels.
Wire tube upper
Wire
Pliers
Feed wheels
To Next Page
Loading...
Need help?
General