en
Important information
Mounting instructions information
These mounting instructions come as part of the Duravit
whirltub and should be read carefully prior to installation.
Explanation of the key words and symbols
DANGER
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
NOTICE
Is used to address practices not related
to physical injury.
Link to the Electrical installation section
Link to the mounting information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak-tightness
Indication of the temperature
Target readership and qualifications
The whirltub must only be installed by trained plumbing
engineers. The electrical installation should only be carried
out by qualified electricians.
NOTICE
Risk of product and/or property
damage!
> Observe the local installation regulations and any
country-specific standards at all times.
Safety instructions
DANGER
Risk of fatal electric shock!
> Do NOT remove any whirltub components.
Mounting instructions
Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
NOTICE
If the tray has a base inlet, a pipe
interrupt must always be installed on-
site. (DIN EN 61770, DIN EN 1717)
> See installation diagram.
Seitenansicht
Lateral view
150
>
=
Gezeichnet
Drafted
GeŠndert
Modified
GeprŸft
Certified
Datum
Date
Name
Ma§stab
Scale
Name
Bezeichnung
Description
Artikel-Nr.
Model-No.
Technische Verbesserungen und optische VerŠnderungen an den abgebildeten Produkten behalten wir uns vor.
We reserve the right to make technical improvements and enhance the appearance of the products shown.
1:20
1:10
1:5
X
# W-T-
Allgaier
000000 - 00 - 0
08.10.13
000000
Schematische Zeichnung mit Rohrunterbrecher
Zeichnung
Drawing
Spezial Ab-und †berlaufgarnitur mit Bodenzulauf
fŸr Badewanne
Special waste and overflow with base inlet
for bathtubs
WLT
08.10.13
16
Checking the whirl system (Diagram 16)
> Switch on the whirl system for 10 minutes:
Run this through once completely in the case of
circuits with different levels of intensity.
> Leave the water in the bathtub and wait 10
minutes.
> Check to make sure that it is leak-tight.
> If adjustments are required, repeat the check.
19
Inspection hatch (Diagram 19)
> The bathtub panel must be accessible and
removable for maintenance.
> Remove the panel with a vacuum suction cup for
maintenance.
(Order number of installation set for free-
standing whirltubs: 790850 00 0 00 0000)
6 WH_M_BlueMoon_FST_with panel/15.11.1
To Next Page
Loading...
