DXV AT200 - Restoring the Default Settings; Storing the Settings; Deodorizer; Auto Seat Open

3333
Restoring the Default Settings
All of the product’s functions can be reset to their factory defaults even after the settings have been changed by the
user. To restore the factory default settings, follow the steps below.
Press the Water temp. button [A] and
Seat temp. [B] buttons simultaneously
for 2 seconds.
* A short beep sounds when the setting is complete.
•Thefactorydefaultsettingsaresummarizedinthetablebelow.
Functions Default setting
Automatic deodorizing ON
Deodorizer mode Automatic switch between “turbo mode” and “
normal mode”
Power save OFF
Seat heater auto off Inactive
Water pressure Levels 2
Dryer temperature Mid
Auto flush ON
Flush delay setting 6 seconds
Night light illumination Bowl base and bowl inside
Signal reception sound ON
Antifreeze OFF
Auto seat open Automatically opens and closes only the toilet
seat lid.
Storing the Settings
The product’s user-defined settings are maintained, even when the power button is turned o or the power plug is
disconnected from the outlet. However, the one-touch power save function is reset when the power plug is discon-
nected. (Page 26)
[A]
[B]
Comfort Features