DXV AT200 - Preventing Freezing - General Measures; Anti-freeze Measures and Auto Drain

5252
If the toilet has been used for a long period of time and flushing or cleansing functions seem to be getting weak, clean
the filters as described in the following procedure. Generally, the filters should be cleaned once every two years.
CleaningtheFilter
1 Closethewatershutoffvalve.
2 Press the Flush/Full or the flush buttons
ontheseatunit.
* Wait for about 20 seconds before performing the next step.
3 Disconnectthepowerplugfromtheoutlet.
4 Remove the side cover on the left side of
theseatunit.(Page51)
5
Place a piece of cloth under the filter on
the left side of the seat unit and remove
thefiltertodraintheseatunit.
6 Thoroughly wash each component in
watertoremovegrime.
7 Fully reattach the filter as shown in the
diagram.
8 Attachthesidecover.(Page51)
9 Connectthepowerplugtotheoutlet.
10Openthewatershutoffvalvefully.
• Whenusingthetoiletagain
Be sure to perform usage checks before use. (Page 14)
[Note]
• Becarefulnottodamagethewatersupplyhosewhenremovingthelter.
CAUTIONCAUTION
• Closethewatershutovalvewhenremovingthelter.
• Wheninstallingthelter,tightenitfullysothereisnogap.
• CheckthattheO-ringisfreefromforeignmaterialsbeforeattachingthelter,asfailureto
dosocouldresultinwaterleakageandooding.
止水栓開.eps
1
2
2
1
1
2
LowWaterPressure