DXV AT200 - Replacing the Nozzle Tip; Removing Nozzle Tips

4646
The Spray nozzle can be cleaned using either of the methods listed below.
● The nozzle can be cleaned using the Nozzle cleaning button on the remote control unit.
● The nozzle can be cleaned manually.
CleaningtheNozzlewiththeRemoteControlUnit
• To clean the nozzle while using the toilet
(sittingontheseat)usingtheremote
controlunit,followtheprocedurebelow.
1 PresstheNozzleCleaningbutton[A].
* The nozzle remains retracted inside the body and is
cleaned for approximately 15 seconds.
* This toilet is equipped with an auto cleaning
function, which cleans the nozzle and surroundings
automatically before and after the rear cleansing,
rear cleansing - mild or front cleansing function.
CleaningtheNozzleManually
•Tocleanthenozzlemanually,follow
theprocedurebelow.
1 TurnofftheAutoClean[B]andAutoSeat
Open[C]buttons.
* This will disable the automatic lid and automatic
flush functions.
2 Lifttheseatlidandseat.
3 PresstheNozzleCleaningbutton.
* Water comes out from a point near the nozzle tips
for approximately 5 seconds. The rear cleansing
nozzle extends and oscillates in a short stroke.
Water is not sprayed during this cleaning function.
[Note]
• TheNozzleCleaningfeatureshouldbeoperatedwhen
thetoiletseatisraised.
* When the toilet seat is lowered, the nozzle does
not extend while it is being washed.
CleaningtheNozzle
[A]
[C]
[B]