DXV AT200 - Page 46

4545
AssemblingtheNozzleGuard
1 While the nozzle is retracted, firmly
press the two tabs into the slots on the
baseasshowninthediagram.
* Press the Stop button to retract the nozzle when
it is out.
[Note]
• Pushthelugsuntilaclickisheard.Checkthatthe
guardiscorrectlyassembled.
• Theguardhasatopandbottom,andmustbe
assembledinthecorrectway.
• Donotuseexcessiveforce,asthiscoulddamagethe
guard.
CleaningtheNozzleGuard