DXV AT200 - Page 66

6565
Miscellaneous
Symptom Cause Solution Page
There are water
drops on the
underside of the
toilet and water
shuto valve.
Humidity is high, forming
condensation.
Frequently wipe water drops.
Also, ventilate the toilet room
adequately.
─
A gurgling sound
is emitted from
the seat unit
When:
● The power plug is
connected to the outlet
● The Power button
is turned on
● The rear cleansing,
rear cleansing
- mild or front
cleansing stops
This is not a problem. It is the sound the motor generates when
the toilet is operating normally. There is no problem as long as
the water water pressure and/or nozzle position can be adjusted
correctly.
─
The power LED is
flashing.
No water is supplied to the
seat unit. (Suspended water
supply, closed water shuto
valve.)
After supplying water, open the
water shuto valve and conduct
a trial operation. If the power
LED still flashes, disconnect the
power plug from the outlet and
contact our company for service.
14
There is a problem with warm
water, toilet seat, drying
function, and/or cleansing
motor.
If the power LED still flashes after
turning the Power button o,
there is a failure. Disconnect the
power plug from the outlet and
contact our company for service.
─
An antifreeze heater is
provided for pipes such as the
water supply hose.
Turn o the antifreeze heater.
When the water temperature
exceeds 104°F[40°C], the safety
device is activated to stop
operation.
─
The rear seat
bumper at the
back of the toilet
seat are not
attached to the
toilet.
This is not a problem. The toilet is designed so that the rear seat
bumper float free. Use the toilet as usual.
─
To reset all
settings to their
default settings.
All functions whose settings
were changed as described in
“Useful functions” are reset to
their default setting.
Press the Water temp. button
and Seat temp. buttons
simultaneously for 2 seconds.
32
Troubleshooting