. .
Dyadic Systems – Mechatronics Cylinder Manual MF-005500-EN-14/63
3.2.3. Parallel Cable Preparation
Please use tips for stranded wire on the ends of all connections.
SCN5 Models (10Kgf Type)
To run from PC Tool Kit (sold separately) only, please connect the power wires (Red: +24V, Black: 0V)
and ILK (Brown: +24V) at this time (see below)
Red: +24V
Black: 0V
Green: FG
(Connect to ground)
White: FG
(Connect to ground)
Orange: ZONE (ZONE signal)
Light Green: (ALM signal output)
Red: PC4
Green: PC8
Yellow: CSTR
White: PC2
Black: PC1
Brown: ILK (Emergency Stop) signal
Connect with +24V
Blue: PFIN (Position Finished)
Gray: ZFIN (Homed)
PNP T
e
To Next Page
Loading...
