. .
Dyadic Systems – Mechatronics Cylinder Manual MF-005500-EN-59/63
8. Maintenance
8.1. Maintenance & Inspection
Please inspect your Mechatronics Cylinder periodically following the chart below.
Check Up Items Points Notes
Mechatronics
Cylinder
Vibration and sound Sound level should not
be higher than usual
Check if there is no noise
increase from regular
operations.
Appearance Clean with cloths and/or
air
Parts clean up No major dust, dirt, oil,
etc.
Clean with cloths and/or air
Tightness of screws No loose screws Tighten screws
Notes: Ambient temperature should be within the specification. If the actual ambient temperature is greater
than the specification, the actuator life will be shortened.
8.2. Warranty
In case of defects discovered upon delivery of your actuator, Mirai Inter-Technologies will replace the defective
products. This warranty doesn’t cover damage to products caused by the customer or incorrect orders by the
customer.
To Next Page
Loading...