Maintenance Manual (960-946) 4-32
Replacement Procedures
1. Release the following screws and separate the LCD Assembly and
Keyboard/Cover Assembly.
Figure 4-36 Removing the Keyboard/Cover Assembly
4.26.2 Installing the Keyboard/Cover Assembly
To install the Keyboard/Cover Assembly, follow the step below and refer to
Figure 4-36.
1. Set the Keyboard/LCD Assembly on the Cover Assembly and secure
them with the screws.
Note: When replacing the Keyboard/Cover Assembly with a new one
■ Stick one piece of Conductive Tape on the cover assembly in place.
As the keytop may fall out, when handling the keyboard, always hold it by
the frame and do not touch the key top.
F2.5x5BT
2
1
LCD Assembly
Keyboard/Cover Assembly
3
4
5
6
To Next Page
Loading...
