dynabook TECRA A50-J Series - Figure 4-22 Removing the Click Pad (1); Figure 4-23 Removing the Click Pad (2)

Maintenance Manual (960-946) 4-22
Replacement Procedures
1. Disconnect the Click Pad FFC and Fingerprint FFC from the
connectors on the Click Pad and the connectors CN9510 and CN9550
on the System Board.
Figure 4-22 Removing the Click pad (1)
2. Remove the square cushion and peel off the gasket tape from the Click
Pad, and then peel off the Click Pad from the Cover Assembly.
Figure 4-23 Removing the Click pad (2)
4.20.2 Installing the Click pad
To install the Click pad, follow the steps below and refer to Figure 4-22 to
Figure 4-24.
1. Stick the Click Pad Mylar to a new Click Pad.
2. Peel off the separator on the Click Pad RIM ASSY and stick the new
Click Pad to the Cover Assembly.
C
C
gp
F
F
F
F
F
F
P
P
Click Pad FFC
d
F
F
F
F
C
C
CN9510
CN9550
Fingerprint
Click Pad FFC
FFC
1
2
Click PadClick PadClick Pad