13
1.1 Battery
The scanner is powered by 1500mAh chargeable Lithium batteries. The batteries can
support the scanner work continuous for 60 hours, or read 56000 barcodes (read an
EAN-13 barcode per 5s).
1.1.1 Mounting the battery (charging)
1) Hold the scanner face down in one hand.
2）Insert USB cable for charging.
1.1.2 How to operate CT10 Barcode Scanner
Turn on the scanner
Press the Power key for about 2 seconds. The scanner will respond with a long beep (high
tone), and its LED indicator is flashing.
Turn off the scanner
Press the Power key for about 3 seconds. The scanner will respond with two short beeps
(high tone) and the LED indicator is turn off.
To Next Page
Loading...
Need help?
General