9
Steps of Setup:
Enter the Setting Mode
For the scanner to enter the setting mode, you must have it read the "Enter Setup"
barcode, which will be located at the bottom of almost every page of this manual.
The CT10 Barcode Scanner will respond with three beeps (tone descending from high to
low), and its LED indicator becomes purple and go off quickly after reading the barcode.
For setting scanner parameters, see "Read a Setup Barcode" below.
Exit the Setting Mode with Save
For the scanner to exit the setting mode, you must have it read the "Exit with Save"
barcode, which will be located at the bottom of almost every page of this manual.
Just like reading the "Enter Setup" barcode, the scanner will respond with three beeps
(tone ascending from low to high) after reading the barcode.
Enter Setup
Details (eg: Enable/Disable a Barcode)
Exit Setup
Enter Setup
Exit with Save
To Next Page
Loading...
Need help?
General