Dynamic CT10 User Manual

21
1.5.2 Continuous Mode
When you active the “Continuous Mode”, you don’t need to trigger the “Scan Key”. After a
successful decoding, the removal of barcode is required. It is not allowed to proceed to
decode until the decoding delay time has passed. To decode the same barcode
repeatedly, move away the barcode and put it back again and again for scanning.
Set the time interval between each decoding for Continuous Mode.
Continuous Mode
Enter Setup
Exit with Save
Exit without Save
Setup Delay between Re-read

Dynamic CT10 Specifications

General

Brand	Dynamic
Model	CT10
Category	Barcode Reader
Language	English