Dynamic CT10 User Manual

27
2.1. Select Output Interface
Either SPP or HID can be chosen depending on the need.
2.1.1 BT SPP Mode
If you select the output interface of BT SPP, you may run HyperTerminal.exe or serial
port tool to collect the scanned data.
You can setup SPP data batch upload or single upload according to your requirements.
SPP Data Batch Upload
SPP Data Single Upload
2.1.2 BT HID Mode
By default, BT HID is activated on the CT10 Scanner, and the keyboard type is set to
PCAT (US).
Enable SPP
（*）Enable HID
Enter Setup
Exit with Save
Exit without Save

Dynamic CT10 Specifications

General

Brand	Dynamic
Model	CT10
Category	Barcode Reader
Language	English