Dynamic CT10

70
3.12 UPC-E
3.12.1 Enable/Disable UPC-E
Decide whether or not to enable UPC-E. The CT10 Scanner defaults enable UPC-E.
3.12.2 UPC-E Checksum Transmission
Decide whether or not to include the checksum character in the data being transmitted.
For example: Do Not Transmit UPC-E Checksum
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-E" barcode;
3. Read the "Do Not Transmit UPC-E Checksum" barcode;
4. Read the "Exit with Save" barcode.
（*）Enable UPC-E
Disable UPC-E
*Transmit UPC-E Checksum
Do Not Transmit UPC-E Checksum
Enter Setup
Enter with Save
Enter without Save