26
Chapter 2 How to Connect with BT
1、Make CT10 full charged, press Power key. If the scanner never connected with the
computer before, it will responds with a beep, and flashing red.
2、Have the scanner read the "Enter Setup" barcode to enter the setting mode.
3、Have the scanner read the associated barcode to activate the BT connection interface.
4、Have the scanner read the barcodes for related settings.
5、Have the scanner read the barcode to exit the setting mode.
6、The CT10 Scanner will stay active for 1 minute waiting for a connection request from
the host(SPP) or trying to connect to the host(HID).
Contents
2.1.Select Output Interface ...................................................................................................... 27
2.1.1 BT SPP Mode ......................................................................................................... 27
2.1.2 BT HID Mode ........................................................................................................ 27
2.2 Setting up a BT connection ............................................................................................... 28
2.3 Connect to PC via BT ....................................................................................................... 29
2.4 Connect to PDA via BT .................................................................................................... 35
2.4.1 One-click Android connection ............................................................................... 39
2.4.2 One-click iOS connection ...................................................................................... 42
2.4.3 Connect via BT Input Method ........................................................................................ 45
To Next Page
Loading...