Inspections and Operations
1.
Press the vibration control button to off
position.
2.
Set the forward/reverse control to the neutral
position.
3.
Turn the throttle control to forward position and
allow the engine to idle for a few minutes to
cool.
4.
Press the parking brake button to activate the
parking brake. Always activate the parking
brake before leaving the machine.
Note If the machine must be parked on a
sloping surface, chock the drums with
wedges to prevent any movement.
5.
Check instruments and warning lamps to see
if any faults are indicated. Switch off all lights
and other electrical functions.
6.
Turn the starter switch to the off position to
stop the engine.
7.
Switch off the battery disconnecter and
remove the key.
To Next Page
Loading...
