DH200F User Manual
©Dyness reserves the copyright of this document.
may result in impaired protection as well as injury to personnel.
Personnel Code of Conduct
Do not change fuse size or rating during installation;
It is not allowed for two or more operators to connect a single wire simultaneously
during the wiring process.
Safety requirements for use
The operator must ensure that: before commissioning and switching off the
disconnecting circuit-breaker, all basic information and step-by-step instructions are
known and, in particular, the safety instructions for assembly and installation must be
strictly observed;
The operator must be equipped with protective clothing and specialized tools in
accordance with local laws and regulations;
Test run after installation
Only put into operation after confirmation by a professional and permission from the
local power department;
Turn off all distribution circuit breakers before operation, and strictly prohibit
disconnection during machine operation.
Battery protection safety
When installing, maintaining and overhauling the equipment, it is necessary to ensure
that:
The storage battery is completely disconnected.
Have a visible warning sign at the point of disconnection to ensure that there are no
accidental reconnections.
Ground Fault Protective Safety
When a ground fault occurs in an integrated energy storage system, the original non-
electrified part may carry high voltage, and accidental electric shock can lead to
personal safety! Ensure that there is no ground fault and take the necessary protective
measures before operation.
Safety of energized measurements
High voltages are present in this equipment, so it is important to protect yourself (e.g.,
wear insulated gloves, etc.) when making measurements with electricity, and you must
be accompanied by a person to ensure your personal safety.
To Next Page
Loading...