Dyness EnerCore DH200F - Storage Requirements

DH200F User Manual
©Dyness reserves the copyright of this document
26
Lifting and transportation
This product is equipped with a lifting ring at the top for lifting, and can be transported
by lifting. When lifting the equipment, at least the following requirements must be met：
 Ensure site safety when lifting.

When lifting and installing, professional personnel should be in charge of the whole
process.
 The strength of the slings used should be able to withstand the weight of the
equipment.

Ensure that all sling connections are safe and reliable, and ensure that each section of
the sling connected to the corner piece is of equal length.

The length of the slings can be adjusted appropriately according to the actual
requirements of the site.
 Make sure that the equipment remains stable and does not tilt during the lifting
process.
 Take all necessary auxiliary measures to ensure the safe and smooth lifting of the
equipment.
Figure 4-1 Lifting and Transportation Diagram
Storage Requirements
Storage Environment Requirements：

To prevent condensation inside the product or soaking of the bottom of the product
during the rainy season, the product should be stored on higher ground.
 The product should be stored on dry, flat, solid ground with sufficient load-bearing