Dyness EnerCore DH200F - Wiring

DH200F User Manual
©Dyness reserves the copyright of this document.
32
Wiring
Only qualified electrical engineers are qualified for electrical connections. Please follow
the requirements given in "Safety Instructions" in this manual. We cannot accept liability
for personal injury or property damage caused by ignoring these safety instructions.
The installation design of the product must comply with the relevant standards or
regulations of the country/region where the project is located.
If the installation is not carried out in accordance with the installation design
requirements given in this manual, resulting in product or system failure, the warranty will
not be covered.
DANGER

Do not touch live parts.
 Before installation, please ensure that the AC and DC sides are not powered on. All
electrical connections must be made when the equipment is completely unenergized.
 Before wiring, the polarity of all input cables must be checked to ensure that the
polarity of each input is correct.
 Do not place the equipment on flammable surfaces.
WARNING

The entry of sand and moisture may damage the electrical equipment in the energy
storage system or affect the performance of the equipment.
 During the sandstorm season, or when the relative humidity in the surrounding
environment is greater than 95%, Electrical connection should be avoided.
 The connection can be started when there is no sand, and the weather is clear.

During the electrical installation, do not pull the cables or wires hard so as not to
damage their insulation properties.

Wiring Tools
Protective items are shown below：
CAUTION

Be sure that all cables and wires should have a certain elasticity.
 Please take necessary auxiliary measures to reduce the pressure on the cables or
conductors.
 After each step of wiring, it is necessary to check carefully to ensure that the wiring is
correct and firm.

All electrical connections must be made in strict accordance with the wiring diagram.