DH200F User Manual
©Dyness reserves the copyright of this document
4 Delivery, transportation and storage
Caution：Failure to transport and store in accordance with the requirements of this
manual may void the warranty.
Table 4-1 Scope of delivery
Please refer to the "Delivery List" for specific
product components.
Certificate of
Conformity(CoC)
Unpacking and Inspection
After receiving the product, please check whether all the delivered components are
complete against the "supply list".
Please check whether the actual received cabinet and the received product model is the
same as the ordered model.
Carefully check whether the product is intact, the transportation process may lead to
equipment collision caused by damage, if you find problems, please contact our
company or the transportation company in a timely manner.
Shipping Requirements
All necessary equipment in the product have been installed and fixed in the cabinet
before leaving the factory, and the product can be transported as a whole during
transportation.
Please confirm that the cabinet doors of the equipment are tightly locked before
transportation.
Be sure to set up warning signs or caution tape to prevent unauthorized personnel
from entering the lifting and transportation area to avoid accidents.
Remove any existing or potential obstacles during the moving process, such as trees,
cables, etc.
Whenever possible, choose favorable weather conditions for transporting the
equipment.
Requirements for equipment transportation mobility
Equipment transportation needs to meet the following conditions:：
Select a suitable crane or lifting tool according to the site conditions. The selected tool
must have sufficient sufficient load-bearing capacity, arm length, and rotation radius.
If movement on slopes or similar conditions is required, additional traction devices may
be necessary.
To Next Page
Loading...