DH200F User Manual
©Dyness reserves the copyright of this document
When carrying out ground transportation, be sure to use ropes to secure the top lifting
ring of the equipment to the transport vehicle to prevent excessive tilting during
transportation.
Throughout the loading, unloading, and transportation process, it is essential to comply
with the outdoor cabinet operation safety regulations of the country/region where the
project is located!
Any machinery used in the operation of the product should be maintained.
All personnel involved in loading, unloading and bolting should be trained accordingly,
especially in safety.
Forklift transport
The bottom of this product is equipped with fork holes specially designed for forklift
transportation. The front and back panels can be removed to reveal the sockets. The
product can be moved through the bottom fork holes on the front and back. If the
installation site is flat, the product can be moved using a forklift. Forklift transportation
methods should meet the following requirements:
The forklift should be equipped with sufficient load capacity.
The length of the pins should meet the requirements of the equipment.
The pins should be inserted into the fork holes at the bottom of the workstation.
When products are transported, moving and lowering should be slow and steady.
Only place the product in a smooth place. The place should be well drained and free of
any obstacles or bulges.
Under no circumstances should the unit be moved by inserting the pins into a position
other than the fork holes
Figure 4-1 Forklift Transport Diagram
To Next Page
Loading...