service manual
Issued 05/05
29
Fitting notes
Refitting the stabiliser
Push the side of the stabiliser out the rear
of the valve assembly.
Locate the end of the stabiliser into the base
of the duct.
Release the other side of the stabiliser
from the base of the duct.
Slide the end of the static cover under the
yoke spigot, then refit the screw.
Align the detail on the other end of the
stabiliser with the rear of the spring mount
assembly. Slide into place. Refit the screw and
washer.
125
127
128
129
126
To Next Page
Loading...
