service manual
Issued 05/05
37
Fitting notes
Removing and refitting the internal
cable
Attach the red wire to the remaining
terminal on the brushbar switch. Dress all
wires neatly within the locators on the duct.
Align the base of the switch cover with the
locators on the duct. Once located lower the
cover onto the duct.
Refit both switch buttons into the top of the
duct. Clip the switch cover in place. Refit the
three screws in the rear of the duct.
Remove the switch cover. Detach the internal
cable from the switches at the top of the duct.
Remove the internal cable from the duct.
Carefully detach the three wires from the top
of the PCB. Detach the internal cable from the
vac motor loom. Carefully snip the cable tie.
Remove the duct cover and duct seal from
the side of the duct. Carefully slide the PCB out
of the duct.
169
172
173
170
171
174
To Next Page
Loading...
