MP-7 Owners Manual 29
Instant Gratification
Multi-Channel Arpeggiator
9. Move the cursor underneath the Category field (as shown above) and
select the “arp” category.
10. Move the cursor underneath the preset name and select any “arp”
preset for channel 1A.
11. Press the “+” Track/Channel select button (located to the left of the
LCD), so that C02A is displayed.
12. Select any other “arp” preset for channel 2A.
13. Select channel 03A and choose another arp preset.
Select Trigger Mode
14. Press the Selector Button in the upper left corner of the Command
Functions section. Pressing this button will switch between Track
Enable/Mute and Triggers mode. Select Triggers mode.
Play it!
15. Now press Trigger Buttons 1, 2 and 3. You should be hearing three
arpeggiators playing at once.
16. Change the arp preset on the current MIDI channel. Since the cursor is
located on the preset name, all your selections will be in the arp
category.
17. Press the Track/Channel button and change the arp presets for
channels 1A, 2A & 3A. Since each factory preset has differently
programmed arpeggiator settings, changing the preset not only changes
the sound, but the arpeggiator as well.
18. You can also play the keypads. You’ll be playing the preset currently
showing in the display.
19. Press the Control Select button above the knobs so that “Quick Edit” is
selected. Adjusting the front panel control knobs now modifies the
preset showing on the LCD.
OO
OO
Sometimes a simple
volume change will bring out
hidden voices and patterns.
20. Press the Control Select button above the knobs again so that
“Volume” is selected. The first three knobs now control the volume of
each arpeggiator preset.
There’s lots more to the arpeggiators. To find out more, refer to the
arpeggiator chapter beginning on page 243.
Time to Save?
If you want to SAVE everything exactly as it is, continue on.
Multisetups save your
entire MP-7 setup. Find out more
on page 146.
1. Press the Save/Copy button.
2. Rotate the data entry control until you get to the menu shown below.
3. Press the right cursor button to move to the lower line.
4. Name your Multisetup so you can find it later, then press Enter.
5. Scroll to the next screen using the data entry control.
6. Move the cursor to the lower line, select a location and press Enter.
To Next Page
Loading...