MP-7 Owners Manual 31
Basic Operations
Basic Operations
The MP-7 front panel contains an LCD screen, 13 velocity & pressure
sensitive performance pads, a bi-directional touchstrip, 49 buttons, and 16
real-time controller knobs. Functions are grouped logically and the controls
are arranged for ease of use.
Power Switch The front panel On/Off switch is a “Soft” power switch that can be used to
turn power on and off when the MP-7 is rack mounted. Use the AC power
switch on the rear panel if you wish to completely disconnect MP-7 from
the AC mains.
The power switch incorporates a “fail-safe” feature when powering down.
Once the power down sequence has begun, you have five seconds to press
the power switch again and stop MP-7 from turning off.
Volume Control This control is the master volume control for all audio outputs. The Volume
Control does not affect any editing or user interface operations. The front
panel volume control is a digital attenuator. For maximum dynamic range,
turn this knob all the way up and control the volume from your mixer or
amplifier.
12VDC Lamp The BNC connector in the upper left corner of the MP-7 panel supplies 12
volts DC at 250 mA to power a standard mixing desk lamp. (Order E-MU
Model Number 7773 - Locking Lamp from your E-MU dealer.)
C01A V127 P00 A:P User
019 raw:Rave Organ
0
To Next Page
Loading...