EDIT MENU
49
Proteus operation manual
Primary
Instrument
Key Range
Key Range
Secondary
Instrument
Crossfade Range
By overlapping the primary and secondary instruments, you can crossfade or cross-switch
between the two layers.
Crossfade Mode
CROSSFADE MODE
This function determines which of the following crossfade modes will be
selected: Off, Crossfade, or Cross-Switch.
Off: When “off” is selected, none of the crossfade parameters will have
any effect.
Crossfade: When “crossfade” is selected, a control input is used to fade
between the primary and secondary. Any modulation source may be
used as an input (velocity, wheel, etc.)
Cross-switch: When “cross-switch” mode is selected, the switched layer
is selected if the input crosses a certain threshold or if a footswitch
controlling cross-switch is activated. The switch occurs only at the start of
the note; no further switching takes place while the key is held down.
If key position or velocity is routed to cross-switch, the threshold is the
switch point. Realtime controllers do not have any effect when routed to
cross-switch. For more information, see Cross-Switch Point on page 51.
XFADE MODE
Off
To Next Page
Loading...
