EDIT MENU
55
Proteus operation manual
Modulation Sources:
Pitch Wheel, MIDI
Control A, MIDI
Control B, MIDI
Control C, MIDI
Control D, Mono
Pressure, Polyphonic
Pressure, LFO 1, LFO
2, Auxiliary Envelope
Destinations:
Off,
Pitch, Primary Pitch,
Secondary Pitch,
Volume, Primary
Volume, Secondary
Volume, Attack,
Primary Attack,
Secondary Attack,
Decay, Primary
Decay, Secondary
Decay, Release,
Primary Release,
Secondary Release,
Crossfade, LFO 1
Amount, LFO 1 Rate,
LFO 2 Amount, LFO 2
Rate, Auxiliary
Envelope Amount,
Auxiliary Envelope
Attack, Auxiliary
Envelope Decay,
Auxiliary Envelope
Release
Realtime Modulation
REALTIME MODULATION CONTROL
These functions allow you to route realtime controllers to any of the
modulation destinations on Proteus except Tone, Sample Start and Pan.
Up to 8 simultaneous patches may be programmed. For each modulation
patch, there is a source and a destination parameter. Place the cursor
under the appropriate parameter and change the patch number, modu-
lation source or modulation destination using the data entry control. If
a parameter is not labeled either primary or secondary, it affects both.
REALTIME CTL
1 LFO1 ->Pitch
Modulation
Source
Modulation
Destination
Patch
Number
LFO 1
Amount Freq.
LFO 2
Amount Freq.
Auxiliary
DAHDSR
AmtAtk Dec Rel
Pan
R
L
R
L
Level
Level
Volume
AHDSR
Atk Dec Rel
DCA
DCA Pan
Atk Dec Rel
Volume
AHDSR
Realtime Modulation Sources
X-Fade
Primary
Instrument
Pitch
Modulation Destinations
LFO 2
AUXILIARY
ENVELOPE
LFO 1
MIDI
CONTROLLER
A/B/C/D
POLY
PRESSURE
MONO
PRESSURE
PITCH WHEEL
Secondary
Instrument
Pitch
To Next Page
Loading...
