CONTENTS
1. TECHNICAL DATA OF THE ACTUATOR
1.1 Dimensions and use restrictions
2. INSTALLATION
2.1 Double-leaf gate
2.2 Actuator installation dimensions
2.3 Position of the rear bracket on brick or block posts
2.4 Position of the front connector (if the manufacturer didn’t provide holes for the front connector)
2.5 Front connector fastening types
2.6 Installing the rear bracket to metal posts
2.7 Installing the actuator arm
2.8 Installing the mechanical limit switches
2.9 Manual unlocking
2.10 Connecting the device
3. CONTROL UNIT INSTALLATION INSTRUCTIONS
3.1 Wiring and connecting
3.2 Central connections
3.3 Electrical connections
4. CONTROL UNIT CONFIGURATION
4.1 Full reset
4.2 Activating the initial configuration
5. REMOTE CONTROLS
5.1 Registering a remote control
5.2 Disconnecting a single remote control
5.3 Disconnecting all remote controls
6. OPTIONS
6.1 Automatic closing
6.2 Slowdown time adjustment
7. SPEED AND SENSITIVITY
7.1 Speed adjustment
7.2 Sensitivity adjustment
8. OPTIONS MENU
8.1 Options 1
8.2 Options 2
9. MANUAL PROGRAMMING
9.1 Setting the closing limit switch
9.2 Setting the opening and delay limit switch
9.3 Setting the closing delay
10. GENERAL INFORMATION
10.1 Intended use
11. SAFETY RECOMMENDATIONS AND WARNINGS
11.1 General recommendations and warnings
12. INSTALLATION RESTRICTIONS
12.1 Installation recommendations and warnings
13. TESTING
14. USAGE RECOMMENDATIONS AND WARNINGS
15. MAINTENANCE
15.1 Maintenance recommendations and warnings
16. DISASSEMBLY AND DISPOSAL
To Next Page
Loading...