EasyWay 210 - Front Connector Fastening Types

2.5 Front connector fastening types
2.5.1 Gate with a rail without holes
- Place the connector in the appropriate position
following the guidelines above, then mark the drilling
location in the centre axis of the connector’s long slotted
holes. Drill with an ∅8.5 drill bit, then ream with a ∅10.5
drill bit from the opposite side (from the roadside).
- Attach the connector with carriage bolts of the
appropriate length, depending on the size of the rail. Use
M8 washers and nuts to tighten the connector.
ATTENTION:
In the case of gates with holes for the connector provided by
the manufacturer, attach the connector following the
guidelines above.
2.5.2 Gate with longitudinal holes
- pre-tighten the M8x16 carriage bolts on the connector using
M8 nuts with washers to ensure slack between the bolt head
and the connector,
- insert one bolt (attached to the connector) into the hole in
the rail and move it as far as possible to the edge, then insert
the second bolt into the other hole,
- slide the bolts fully outwards, then tighten the M8 nuts.
- by loosening the nuts, it’s possible to adjust the position of
the connector on the connector’s long slotted holes.
32