Eaton 9355 - Figure 63. Removing Knockout Tabs; Figure 64. Reinstalling the Front Covers

Eaton 9355 UPS (10/15 kVA) User’s Guide 164201594—Rev H0 77
Figure 63. Removing Knockout Tabs
4. Route the cable(s) to the approximate location of the cover access holes.
5. Connect the cables to the appropriate location.
See Chapter 6 Communication or paragraph 6.3 Control Terminals for detailed information.
6. Reinstall the front covers, starting with the bottom cabinet (see Figure 64).
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place. Verify
that the cables fit in the access holes in the covers.
Figure 64. Reinstalling the Front Covers
7. Proceed to Chapter 7 UPS Operating Instructions to start up the UPS.
NOTE After UPS startup, ensure maximum battery runtime by configuring the UPS for the
correct number of EBMs (see paragraph 7.6 Configuring the UPS for EBMs).
Communication