Eaton 9355 - Figure 68. RMP Dimensions

Eaton 9355 UPS (10/15 kVA) User’s Guide 164201594—Rev H0 81
Figure 68. RMP Dimensions
Mounting Slots
(6 places)
NOTE Matches mounting holes on a single- or
double-gang electrical box.
Cable Exit Openings
for 1/2” Conduit or
Provided Strain Relief
(3 places)
Dimensions are in mm [inches]
To install an RMP:
NOTE If mounting to a hollow wall, secure the enclosure bottom to a wood or metal stud
within the wall. Do not use hollow wall anchors. The RMP can also be mounted to a
single- or double-gang electrical box.
1. If wall mounting, securely mount the RMP. Proceed to Step 2.
If desk mounting, install the provided bumpers to the bottom of the RMP enclosure. Proceed to Step 3.
2. Install 1/2” conduit from the RMP to the IRC through the cable exit openings (see Figure 68). Proceed to
Step 4.
3. Install wiring from the RMP to the IRC using the cable listed in Table 8 and the provided strain relief
bushings in the cable exit openings in the IRC (see Figure 70) and the RMP.
4. Connect the wiring between the RMP and the IRC plug–in terminal blocks using terminations shown in
Table 8. See Figure 69 and Figure 70 for plug–in terminal block locations.
Communication